地下停车库空气污染物排放实测研究

通过对上海市某商业地下停车库库内及排风管道的连续监测,获得了CO、NO、非甲烷总烃(NMHC)、PM10等空气污染物浓度数据。结果表明:(1)地下停车库的休息日车流量明显大于工作日,且工作日小时车流与车位比为20%~50%、休息日小时车流与车位比为20%~80%。(2)总体上,地下停车库内CO、NO、NMHC浓度呈明显变化规律,营业时间现峰值,非营业时间现谷值;地下停车库内CO、NO、NMHC变化规律和车库排风中具有较好的一致性。(3)车库排风中污染物浓度水平均低于地下停车库内。(4)营业时间的CO、NO、NMHC小时浓度平均值明显增大,约为非营业时间的2.42~3.67倍。(5)单车次CO、NOX、NMHC排放量最大值分别为0.855、0.070、0.214g/(辆·次)。(6)营业时间,除地下停车库内CO外,NO、PM10的8h时间加权平均值符合《工作场所有害因素职业接触限值化学有害因素》(GBZ 2.1—2007,其中未规定NMHC)中时间加权平均容许浓度(PC-TWA);地下停车库内CO出现33.3%的超标频率,最大占标率104%。     

牡蛎壳生物滤池处理含盐污水中的硝化特性

采用牡蛎壳为曝气生物滤池填料,以含NaCl的生活污水为处理对象,在SBR操作条件下,系统考察进水NaCl浓度、曝气时间及进水pH值等对硝化性能的影响。结果表明,进水NaCl浓度为10~15 g/L时,平均氨氮去除率可稳定在97%以上;较高浓度NaCl对亚硝酸化菌活性影响较弱,对硝酸化菌活性影响较强,特别是在日曝气时间少于12 h时,其出水中亚硝氮的含率大于50%;当进水pH值在6~9变化时,反应器内pH值可稳定在6.5~7.5,硝化性能良好,表明牡蛎壳填料可为硝化反应提供碱度。     

UV/Fenton技术处理某工厂高浓度乳化油废水

研究了UV/Fenton技术对高浓度金属清洗乳化油废水的处理效果,考察了亚铁与双氧水浓度、pH、反应时间和搅拌对COD去除效果的影响。实验结果表明,UV/Fenton技术对高浓度乳化油废水(COD平均浓度为35 000 mg/L)具有较高的去除效果,最佳工艺条件为:亚铁与双氧水浓度分别为2 400 mg/L和6 000 mg/L,pH为3,经过2 h反应,COD可降低至1 050 mg/L,去除率为97%。搅拌会降低COD的去除率。研究表明,UV/Fenton技术对高浓度乳化油废水具有很好的降解效果,且药品消耗较低,为目前此类高浓度有机废水的处理提供了技术参考。     

大数据解析技术在大气环境监测中的应用研究

针对近年来新兴的大数据及挖掘、分析技术,对大数据解析技术在环境科学研究中的应用进行了分析和探析。以城市局部地区大气细颗粒污染物PM2.5浓度计算为例,筛选了PM2.5浓度历史数据、气象条件、交通状况、人群活动情况、网格道路状况等数据为影响特征量,分析了用神经网络法进行大数据解析和推演的原理和数学过程,是用数学、计算机、统计等方法研究解决多元、非线性复杂环境问题的一种新的探索。     

A method to estimate the impact of clear-cutting on nutrient concentrations in boreal headwater streams

Large-scale forestry operations, like clear-cutting, may impair surface water quality if not done with environmental considerations in mind. Catchment and country level estimates of nutrient loads from forestry are generally based on specific export values, i.e., changes in annual exports due to the implemented forestry operations expressed in kg ha⁻¹. We introduce here a specific concentration approach as a method to estimate the impact of clear-cutting on nutrient concentrations and export in headwater streams. This new method is potentially a more dynamic and flexible tool to estimate nutrient loads caused by forestry, because variation in annual runoff can be taken into account in load assessments. We combined water quality data from eight boreal headwater catchment pairs located in Finland and Sweden, where the effect of clear-cutting on stream water quality has been studied experimentally. Statistically significant specific concentration values could be produced for total nitrogen, nitrate, ammonium, and phosphate. The significant increases in the concentrations of these nutrients occurred between 2 and 6 years after clear-cutting. Significant specific concentration values could not be produced for total phosphorus and total organic carbon with the whole dataset, although in some single studies significant increases in their concentrations after clear-cutting were observed. The presented method enables taking into account variation in runoff, temporal dynamics of effects, and the proportional size of the treated area in load calculations. The number of existing studies considering large site-specific variation in responses to clear-cutting is small, and therefore further empirical studies are needed to improve predictive capabilities of the specific concentration values.     

Evidence of new particle formation during post monsoon season over a high-altitude site of the Western Ghats,India

The formation of ultrafine particles, their growth, and associated characteristic features has been studied during new particle formation events over a high-altitude station of the Western Ghats during the 2014 post-monsoon season. Most of the events were observed during noon time where particle bursts in the nucleation-mode size range from 5 to 25 nm followed by sustained growth in size. This phenomenon persists for ～4–8 h with a growth rate of 1–2 nm h^–1. Peak concentrations of nucleation-mode particles during the event generally vary from 2300 to 5000 cm^–3. The mean growth rate is 1.4 ± 0.42 nm h^–1, particle formation rate is 1.14 ± 0.22 cm^–3 s^–1, coagulation sink is 0.35 ± 0.22 cm^–3 s^–1, and condensational sink is 15.4 ± 2.6?×?10^–3 s^–1. All these values are comparable with earlier results from Indian region. Comparison of size-segregated particle number concentration during days of new particle formation events and those without new particle formation were carried out showing a distinct variation in nucleation and Aitken mode with least variability associated with the accumulation mode.     

农药混配制剂环境风险评估现状与展望

本文综述了欧洲和美国农药混配制剂的环境风险评估方法。详细介绍了欧洲食品安全局(EFSA)评估体系中的2种方法,即,基础的"整体测试法"和近年来提倡的"基于组分的方法"。"基于组分的方法"的特点是以浓度加和模型(CA模型)作为默认假设进行初级评估,以独立作用模型(IA模型)等作为高级评估手段的农药混配制剂环境风险评估方法。此外,本文还介绍了模型偏差率(MDR)、毒性相似度及毒力单元(TU)等概念以及混配制剂风险评估流程。本文的目的旨在为建立我国农药混配制剂的环境风险评估方法体系提供参考。     

焊点热疲劳失效原因分析

某PCBA样品在使用约半年后出现功能失效,该PCBA在封装后进行整体灌胶,将失效样品剥离,发现部分器件直接脱落,通过表面观察、切片分析、EBSD分析、应力分析、热膨胀系数测试等手段对样品进行分析,结果表明:各封装材料存在热失配,且焊点缺陷较多且存在应力集中区,加速焊点的疲劳失效进程,导致PCBA功能失效。     

An experimental apparatus for testing biodiesels based on a CFR engine—setup and validation with different methyl ester blends

A cooperative fuel research (CFR) engine was modified and instrumented in order to control operating conditions and to measure engine parameters and in-cylinder pressure diagrams. Aiming at the comparison of different alternative fuels, an experimental procedure was defined, including cetane number (CN) evaluation and the definition of engine operating quantities in different working points, for fixed levels of compression ratio (CR) and injection advance. An investigation was made considering several blends of methyl-esters of rapeseed oil (RME) and of a mix of vegetable oils (VOME) with conventional diesel oil. The defined experimental procedure was applied to assess CN, engine brake thermal efficiency (bte) and exhaust emissions. Results show that the biodiesel content has a positive influence on soot emissions, with strong reduction, while thermal efficiency and NO_X emissions are negatively affected, which can be justified taking into account fuel properties and changes in combustion process. As observed outcomes are generally in line with those presented in literature, the facility proved to be a suitable tool for basic investigations on alternative fuels to be used in specific applications.     

基于小波变换与传统时间序列模型的臭氧浓度多步预测

采用最大重叠小波分解与重构方法,将影响O3小时浓度的不同时间尺度的物化过程分离出来,以提高序列的光滑性.同时,选择合适的传统时间序列模型(如ARIMA模型等)来描述不同过程的序列特征,并分别拟合预报.最后,在建模中引入24 h季节项,以实现提前24 h-次性预测未来1d的O3逐时浓度.结果表明,预报的平均相对误差为12.92％,平均绝对误差和均方根误差分别为10.04 μ.g·m-3和13.98μg·m-3,预报值与实测值的相关系数和匹配指数分别为0.96和0.98.随着预测期的延长,预报误差仍处于可接受范围内.该方法同样适用于每日最大O3小时浓度预报,研究结果为发布天气预报式的空气质量预报提供了新思路,便于公众规划出行并减少大气污染暴露.